Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
USER MANUAL
7 / STARTING UP
CONTROL PANEL
4=Control button right clamps
7=
Regulation of the speed of
advance of the left blade.
2
=Stop blades button
MAIN SWITCH
YOU MUST HAVE REMOVED THE LOCKING SQUARE (E) OF THE BLADES CARRIAGES BEFORE FOLLOWING
THIS PROCEDURE : SEE PAGE 19 OF THE INSTRUCTIONS MANUAL (
Open the compressed air source (Valve 14) and adjust the machine pressure regulator (13) to obtain compressed air pressure
of 6 bar.
Switch on the machine: main isolating switch (16) at bottom right of the machine.
Indicator lamp V1 lights up. This indicator lamp V1 only lights if the CS 969 is energised.
Press button 1 (Fig. Below) and check the rotation direction of the blades, i.e.:
a/ clockwise for the left blade,
b/ anti-clockwise for the right blade.
If the direction is not correct, press button 2 (Fig., Below), close the valve (14), put the main switch on OFF and reverse
two phases on the power supply cable.
Restart the starting up.
3=Lock / Unlock Cover
1
=Start blades button
16
13
14
Figure 7-2
9=Retractable stop or Numeric stop option
5=Control button left clamps
6=Control button left and right clamps
8=
Regulation of the speed of
advance of the right blade
V1
=Machine
operationnal lamp
REMOVING OF TRANSPORTATION SAFETY)
CS969
Figure 7-1
.
28
Publicité
Table des Matières
