Changing The Brake Fluid; Drive Chain Slack - Benelli BN125 Manuel Du Propriétaire

Periodic maintenance and adjustment

Changing the brake fluid

Have a Benelli dealer change the brake
fluid at the intervals specified in the pe-
riodic maintenance and lubrication chart.
EN
6

Drive chain slack

The drive chain slack should be checked
before each ride and adjusted if necessary.
To check the drive chain slack
1. After stopping the engine, place the
vehicle on a rear stand on a horizontal
surface and with the gear in neutral, or
centerstand.
2. Measure the drive chain slack as shown.
Drive chain slack:
10 - 15 mm
3. After running the rear wheel forward
occur else where in the free play chain: it
must be constan.
6 - 20
4. If the drive chain slack is incorrect,
adjust it as follows.
NOTICE
Using the motorcycle with the chain in
bad condition and badly adjusted may
cause accidents.
If you notice any operating anomaly on
the chain, such as excessive or suspi-
cious noises, or excessive slack, go to
an authorised Benelli workshop.
If you suspect that there is a serious
malfunction with the chain, stop the
bike immediately and call your nearest
Benelli authorised workshop.