Installation; Unpacking And Inspection; Preparation; Mounting The Unit - INFOSEC UPS SYSTEM C3 MPPT Manuel De L'utilisateur

2. INSTALLATION

2-1. Unpacking and Inspection

Before installation, please inspect the unit. Be sure that nothing inside the package is damaged. You
should have received the following items inside of package:
 C3 MPPT / C3+MPPT x 1
 User manual x 1
 USB cable x 1
 RS232 Cable x1
 Software CD x 1

2-2. Preparation

Before connecting all wirings, remove the bottom cover by releasing the two screws as shown below.

2-3. Mounting the Unit

Consider the following points before selecting where to install the
unit:
 Do not mount C3 MPPT / C3+MPPT on flammable
construction materials.
 Mount on a solid surface.
 Install C3 MPPT / C3+MPPT at an eye level in order to be
able to read the LCD screen at all times.
 The ambient temperature should be between 0°C and 55°C
to ensure an optimal operation.
 The recommended installation position is against a wall,
vertically.
Make sure to keep other objects and surfaces as shown in

the right diagram to guarantee sufficient heat dissipation
and to have enough space for removing wires.
SUITABLE FOR MOUNTING ON CONCRETE OR
OTHER NON-COMBUSTIBLE SURFACE ONLY.
Install the unit by screwing three screws. It is recommended to
use M4 or M5 screws.
INFOSEC UPS SYSTEM - 4, rue de la Rigotière - 44700 Orvault - FRANCE - www.infosec-ups.com
Hot Line – Tel + 33 (0)2 40 76 15 82 - Fax + 33 (0)2 40 94 29 51 - hotline@infosec.fr – 06 15 AA 59 203 33
Diagram 5: Removing the rear panel of C3 MPPT/C3+ MPPT
Diagram 6: Installation of C3 MPPT / C3+MPPT
7