Dometic 5 Série Instructions De Montage page 17

RM53xx
• This refrigerator may only be repaired by qualified personnel. Inade-
quate repairs may cause serious hazards.
• Only use propane or butane gas (not natural gas).
• Only operate the refrigerator at the pressure shown on the type
plate. Only use pressure controllers with a fixed setting which comply
with the national regulations (in Europe EN 12864).
• Dismantle all refrigerator doors for the disposal of the old refrigerator
and leave the shelves in the refrigerator to prevent accidental enclo-
sure and suffocation.
!
CAUTION!
• Danger of crushing! Do not put your fingers into the hinge.
• Before starting the device, ensure that the power supply line and the
plug are dry.
A
NOTICE!
• Only hold the refrigerator at the body of the refrigerator during trans-
port. Never hold the refrigerator at the absorber unit, the cooling fins,
the gas pipes, the door or the control panel.
• Make sure that the refrigerator circuit is not damaged during transpor-
tation. The refrigerant in the refrigerator circuit is highly flammable.
In the event of any damage to the refrigerator circuit (smell of ammo-
nia):
– Switch off the refrigerator if applicable.
– Avoid naked flames and sparks.
– Air the room well.
• Do not install the refrigerator near naked flames or other heat sources
(heaters, direct sunlight, gas ovens etc.).
• Danger of overheating!
Always ensure sufficient ventilation so that the heat generated during
operation can dissipate. Make sure that the refrigerator is sufficiently
far away from walls and other objects so that the air can circulate.
• Check that the voltage specification on the type plate is the same as
that of the power supply.
• Do not open the refrigerant circuit under any circumstances.
• Only use the AC connection cable supplied to connect the refrigera-
tor to the AC mains.
• Only use cables with a suitable size.
• Never pull the plug out of the socket by the connection cable.
EN
Safety instructions
17