Spare Parts - Swiss Made Xplorer Traduction De La Notice Originale

Malfunction
Battery charge runtime
too short and/or blades
become hot.
Lowest LED on char-
ger is not lit.
Normal charging does
not start when the
discharged battery is
inserted.
Lowest LED alternates
between green and
red.
Top LED lights up red.

9 Spare parts

See spare parts list at the end of these operating instructions.
Incorrect or defective spare parts can lead to damage, malfunction and complete
failure and can jeopardise safety.
► Use only original spare parts from the manufacturer. Obtain spare parts from an
authorised dealer or directly from the manufacturer.
► If non-approved parts are used, all warranty, service, compensation and liability claims
against the manufacturer or its employees, dealers and representatives will be forfei-
ted.
Cattle and Horse Clippers
Possible cause
Clipping blades not lubricated
adequately.
Discharged, not fully charged
or defective batteries were
used.
The charger is not connected
to the power supply.
Electronics or power pack is
defective.
Battery terminals and/or char-
ger are dirty.
Battery is faulty.
Electronics are defective.
Battery is deeply discharged,
the charger is trying to boost
the battery voltage.
Battery is faulty.
CAUTION
NOTE
Corrective measure
Oil clipping blades.
Only use intact, fully charged
original batteries.
Connect charger to the power
supply.
Notify customer service.
Clean the terminals.
Replace battery.
Notify customer service.
If it is successful, normal char-
ging starts. (store batteries that
have never discharged).
If it is not successful, the lowest
LED lights up red (see the fol-
lowing table).
Replace battery.
43