Adjusting The Clipping Pressure; Switching The Clipper On And Off; Using The Clipper - Swiss Made Xplorer Traduction De La Notice Originale

1
2
3

7.5 Adjusting the clipping pressure

Abb. 8
► If the clipping pressure is too low, hair can gather between the clipping blades. This
results in a poor clipping quality. In this case, clean the clipping blades as described in
chapter 6.10.

7.6 Switching the clipper on and off.

Abb. 9

7.7 Using the clipper

Approach the animal from the front.
‹
Secure the animal to be clipped and calm it down.
‹
Switch the clipper on while you are in the visual range of the animal.
‹
Observe the animal's behaviour while clipping.
‹
Cattle and Horse Clippers
Defective battery
If the battery cannot be charged or the battery is defective,
the top LED flashes red.
Set the clipping pressure as follows before you start
clipping:
Turn the adjusting knob in the direction of the
‹
arrow until you feel resistance.
Turn the knob another 1/4 turn in the direction
‹
of the arrow.
If the clipping quality deteriorates, increase the
‹
clipping pressure by turning the adjusting knob
another 1/4 turn in the direction of the arrow.
If this does not produce the desired result, the
blades must be replaced or sharpened.
NOTE
To switch the clipper on, slide the ON/OFF
‹
switch to the position I.
To switch the clipper off, slide the ON/OFF
‹
switch to the position 0 (see Fig. 9)
37