Replacing The Clipping Blades - Swiss Made Xplorer Traduction De La Notice Originale

Switch the clipper off after you have finished clipping.
‹

7.8 Replacing the clipping blades

Abb. 10
Abb. 11
Abb. 12
38
Switch the clipper off by sliding the switch to
‹
the position "0".
Turn the adjusting knob in the direction of the
‹
arrow until the resistance decreases.
Place the clipper with the comb plate screws
‹
facing up onto a flat surface.
Loosen the comb plate screws and remove the
‹
clipping blade.
► Make sure the clipping blades are positi-
oned correctly when installing the new or
sharpened blades.
NOTE
Cattle and Horse Clippers