Technical Specifications - Bosch CTL636E.6 Mode D'emploi

Problem
Display shows
"Empty drip trays"
despite them being empty.
Display shows
"Insert drip trays"
even though drip tray in
use�
Very frequent display that
descaling is necessary.
Water dripped onto the
inner floor of the appli-
ance when the drip tray
was removed.
Display shows
"Switch off with power
switch, then back on after
30 sec!"
Home Connect does not
work correctly.
If you are unable to solve the problem, always call the hotline!
You will find the telephone numbers at the back of these instructions.

Technical specifications

Power connection (voltage – frequency)
Power rating
Maximum static pump pressure
Maximum water tank capacity (without filter)
Maximum capacity of the coffee bean container
Length of power cable
Dimensions (H x B x D)
Weight, empty
Type of grinding unit
Cause
Drip tray is soiled and wet.
Emptying is not detected
when the appliance is
switched off.
Inside of appliance
(tray holder) dirty.
The coffee grounds container
is not fully inserted.
Water is too hard�
Drip tray was removed too
soon�
Appliance is too warm.
Dirty brewing unit.
Technical specifications
Solution
Clean and dry the drip tray
thoroughly.
When the appliance is switched
on, remove and re­insert the
drip tray.
Clean the inside.
Push the coffee grounds
container all the way in.
Insert water filter and configure
settings accordingly in the
menu�
Wait a few seconds after the
last drink was dispensed before
removing the drip tray.
Leave the appliance to
cool down.
Clean the brewing unit.
Go to
www.home­connect.com
220­240 V – 50/60 Hz
1600 W
19 bar
2.4 l
500 g
1�7 m
455 x 495 x 375 mm
19­20 kg
Ceramic
en
65