Making Coffee With Ground Coffee; Making Coffee With Coffee Beans - Gaggia TITANIUM PLUS Mode D'emploi

ENGLISH
Turn the knob (19) to adjust the coffee density.
Turn the knob:
• left for a weak coffee;
• in the middle for a medium coffee;
• right for a strong coffee.
8 ThE coffEE DIspENsER
Note: If the appliance does not dispense coffee, check
the water level in the tank.
• Before dispensing coffee, check that the water tank and coffee
container are full and that the display shows:
SELECT PRODUCT
READY FOR USE
• Place 1 or 2 coffee cups under the coffee dispenser spouts; you can
adjust the height of the dispenser by moving it up or down manually
(Fig.12) until it suits your cups.

8.1 Making coffee with coffee beans

• To dispense coffee press the coffee dispenser button (22, 23 or 24);
the display will indicate (for example)
1 SMALL COFFEE
Dispense 1 coffee, place a single cup beneath the coffee spouts and
press the button (22, 23 or 24) only once; to dispense 2 coffees,
place two cups beneath the coffee spouts and press the button (22,
23 or 24) twice; the display will show:
2 SMALL COFFEES
In this operating mode, the appliance automatically grinds and
doses the right quantity of coffee; making two coffees requires two
grinding and dosing cycles, which are automatically managed by
the machine.
• Then the dispensing cycle starts.
• After undergoing a pre-brewing cycle, coffee will start to come out
of the spout (Fig.01, pos.13).
The coffee will stop flowing automatically when the preset level is
reached (see section 8.3). You can interrupt the flow of coffee by
pressing the button (Fig.01, pos.22 23 or 24).
8.2

Making coffee with ground coffee

In this operating mode, you must use the scoop provided
(Fig.01, pos.21) to measure out the ground coffee.
Only use ground coffee suitable for espresso coffee
makers in the doser (5); placing coffee beans, instant
coffee and other materials inside the doser causes damage to
the appliance.
Keep fingers away from the ground coffee doser since
there are moving parts.
Use the scoop provided (21) to measure out the right quantity of ground
coffee to place in the doser .
Use only one full measuring scoop at a time; to make two coffees, you
must go through the entire process twice.
• Press the button (25) to select the function; the display will show:
SELECT PRODUCT
PREGROUND COFFEE
• Lift the cover of the ground coffee doser (Fig.13).
• Fill the scoop with one measure of coffee; discard any excess ground
coffee.
• Fill the doser with the ground coffee (Fig.14)
• Close the cover of the ground coffee doser.
• To dispense coffee, press the coffee dispenser button (22, 23 or 24);
the display will show (for example)
1 SMALL COFFEE
PREGROUND COFFEE
• The dispensing cycle will start.
• After undergoing a pre-brewing cycle, coffee will start to come out
of the spout (13).
The coffee will stop flowing automatically when the preset level is
reached (see section 8.3). You can interrupt the flow of coffee by
pressing the button (22 23 or 24).
• 0 •