Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Wet cutting with water supply hose
CAUTION:
Always pay attention to the control
of water pressure. Too high water pressure may
cause water leak and splashing.
1.
Set the water supply lever in the "ON" (I) position.
1
2
3
► 1. Water supply lever 2. "ON" (I) position 3. "OFF" (O) position
2.
Start feeding water to the diamond wheel by turning the
mains water supply on. Water flow can be adjusted by moving
the water supply lever. Turn the lever to the "ON" (I) position to
increase flow, and to the "OFF" (O) position to reduce flow.
3.
Hold the tool firmly. Set the base plate on the workpiece
to be cut without the diamond wheel making any contact.
4.
Turn the tool on and wait until the diamond wheel
attains full speed. Then move the tool forward over
the workpiece surface, keeping it flat and advancing
smoothly until the cutting is completed.
5.
Having finished operation, be sure to set the lever in
the "OFF" (O) position to cut flow off and turn the water off.
WIRELESS ACTIVATION
FUNCTION
NOTICE:
The wireless function is only available when the
dust cover and supported vacuum cleaner are being installed.
What you can do with the wireless
activation function
The wireless activation function enables clean and com-
fortable operation. By connecting a supported vacuum
cleaner to the tool, you can run the vacuum cleaner
automatically along with the switch operation of the tool.
To use the wireless activation function, prepare following items:
•
A wireless unit (optional accessory)
•
A vacuum cleaner which supports the wireless
activation function
The overview of the wireless activation function setting is
as follows. Refer to each section for detail procedures.
1.
Installing the wireless unit
2.
Tool registration for the vacuum cleaner
3.
Starting the wireless activation function
Installing the wireless unit
Optional accessory
CAUTION:
Place the tool on a flat and stable
surface when installing the wireless unit.
NOTICE:
Clean the dust and dirt on the tool
before installing the wireless unit. Dust or dirt
may cause malfunction if it comes into the slot of the
wireless unit.
NOTICE:
To prevent the malfunction caused by
static, touch a static discharging material, such
as a metal part of the tool, before picking up the
wireless unit.
NOTICE:
When installing the wireless unit,
always be sure that the wireless unit is inserted
in the correct direction and the lid is completely
closed.
15 ENGLISH
Publicité
Table des Matières
