Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
45° bevel cutting
Wet cutting operations
Install the optional water supply cover and accessories
before performing wet cutting operations.
CAUTION:
Be sure to feed water to a wet-type
diamond wheel during wet cutting operations.
Wet cutting with water supply tank
CAUTION:
Avoid filling the water supply tank
with unclean water, such as muddy water, or else
the water outlet will be blocked resulting in dam-
age to the tool.
NOTICE:
Be sure to drain out water from the water
supply tank completely after each use.
1.
Open the lid-cap of the water supply tank, and fill
the tank with water. Then set the water-filled tank in the
water supply holder of the tool.
► 1. Lid-cap
2.
workpiece to be cut without the diamond wheel making
any contact.
3.
ing the water supply lever towards the "ON" (I) position.
Water flow can be adjusted by moving the water supply
lever. Turn the lever to the "ON" (I) position to increase
flow, and to the "OFF" (O) position to reduce flow.
2
► 1. Water supply lever 2. "ON" (I) position 3. "OFF"
1
4.
attains full speed. Then move the tool forward over
the workpiece surface, keeping it flat and advancing
smoothly until the cutting is completed.
5.
in the "OFF" (O) position to cut flow off.
14 ENGLISH
Hold the tool firmly. Set the base plate on the
Start feeding water to the diamond wheel by pull-
1
3
(O) position
Turn the tool on and wait until the diamond wheel
Having finished operation, be sure to set the lever
Publicité
Table des Matières
