Makita DCC500 Manuel D'instruction page 12

Masquer les pouces Voir aussi pour DCC500:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Water supply tank
Optional accessory
CAUTION:
When filling the tank with water, be
careful not to spill water over the tool.
CAUTION:
Be sure that the water supply lever
on the wheel cover is set in the "OFF" (O) position
before installing the water supply tank.
Installing water supply tank
Insert the tank with the water supply cap pointing down-
wards into the water supply holder until it locks with a
click.
1
2
► 1. Water supply cap 2. Water supply holder
Removing water supply tank
Press the eject button to release the tank, and then pull
the tank off.
► 1. Eject button
1
NOTICE:
Be careful not to hold the water-filled tank
upright (with its lid-cap facing downwards) as water
drops may leak out of the vent pin hole.
► 1. Lid-cap 2. Vent pin hole
Water supply hose
Optional accessory
CAUTION:
Be sure that the water supply lever
on the wheel cover is set in the "OFF" (O) position
before turning the water on.
Connecting to the mains water
supply
NOTE: The type of water outlet may vary depending
on your region of residence. Use an appropriate
faucet adapter or tap connector to attach the hose to
the mains water supply as necessary.
1.
Connect the water supply plug to the supply water
outlet.
► 1. Supply water outlet 2. Water supply plug
12 ENGLISH
2
1
1
2

Publicité

Table des Matières
loading

Table des Matières