Makita DCC500 Manuel D'instruction page 13

Masquer les pouces Voir aussi pour DCC500:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

2.
Unscrew the water supply cap attached to the
water supply tank.
2
1
► 1. Water supply cap 2. Water outlet
NOTICE:
Be careful not to lose the rubber washer
placed at the bottom of the water supply cap when-
ever you reassemble the cap.
3.
Attach the water supply cap onto the cap plug of
the hose.
► 1. Water supply cap 2. Cap plug
4.
Insert the hose with the water supply cap pointing
downwards into the water supply holder until it locks
with a click.
1
2
► 1. Water supply cap 2. Water supply holder
Disconnecting from the mains water supply
1.
the "OFF" (O) position and turn the water off.
2.
hose, and then pull the hose off.
► 1. Eject button
3.
water outlet.
2
1
Hold the tool firmly. Set the base plate on the workpiece
to be cut without the diamond wheel making any con-
tact. Then turn the tool on and wait until the diamond
wheel attains full speed. Now simply move the tool
forward over the workpiece surface, keeping it flat and
advancing smoothly until the cutting is completed. Keep
your cutting line straight and your speed of advance
uniform.
Straight cutting
13 ENGLISH
Set the water supply lever on the wheel cover in
Press the eject button to release the water supply
1
Remove the water supply plug from the supply
OPERATION
CAUTION:
THIS TOOL SHOULD ONLY BE
USED ON HORIZONTAL SURFACES.
CAUTION:
Be sure to move the tool forward
in a straight line and gently. Forcing and exerting
excessive pressure or allowing the wheel to bend,
pinch or twist in the cut can cause overheating of the
motor and dangerous kickback of the tool.

Publicité

Table des Matières
loading

Table des Matières