Control Panel - onsen ON-I14L-LP Manuel D'installation Et D'utilisation

ROUTINE START UP
1
Ensure all drain plugs are installed in unit.
2
Ensure all hot water use points (faucets, etc.)
are shut off.
3
Open the water inlet valve.
4
Open a hot water faucet to confirm water
flow and then shut off the faucet.
5
Open the fuel gas valve.
6
Plug in the unit.
7
Press the "ON/OFF" key to turn on the unit.
8
Set temperature (see "Temperature Control"
in section "Operating Instructions" of this
manual).

CONTROL PANEL

The control panel and display are used to adjust the operational settings of the unit as well as give information
about the current state of operation. The following illustration shows all possible symbols and signs that may
appear in various states of operation. While in operation, only the symbol or sign corresponding to the actual
state will appear on the control panel display. The water heater is in an operating state when the hot water
temperature is shown.
Temperature setting
Flame indicator
Eco mode
onsenproducts.com
8
onsenproducts.ca
Control Panel Diagram
Eco mode
Mode
Selection
On/Off Increase
800-996-5559
Water inlet valve
Fuel gas valve
High mode
Comfort mode
Low mode
Water flow indicator
Fan motor indicator
Decrease
support@onsenproducts.com