Maintenance And Inspection; Routine Inspection - onsen ON-I14L-LP Manuel D'installation Et D'utilisation

NO FLOW DUE TO EXPECTED FROZEN HEATER
Follow these steps if a frozen heater is suspected:
1
Close both the fuel gas valve and the water inlet valve.
2
Turn off the power switch.
3
Open a hot water faucet.
4
Open the water inlet valve and check for water flow.
5
If no flow, attempt to thaw heater by using a portable heat source such as a hair dryer or portable electric
heater.
6
Check occasionally to see if water flow has started.
7
When water flow resumes, carefully check for any signs of water leakage.
8
Resume normal operation.
WARNING
WARRANTY
Damage caused by freezing is NOT covered by the warranty.

MAINTENANCE AND INSPECTION

ROUTINE INSPECTION

CAUTION
To keep your water heater operating optimally please refer to the below recommended inspection and
maintenance checklists. Onsen recommends a periodic inspection performed by a qualified service technician.
An annual inspection is normally sufficient. Frequent visual inspections by the owner are recommended. Any
repairs should be performed by a qualified service technician using only factory authorized components.
onsenproducts.com
onsenproducts.ca
To prevent damage, NEVER force a heater to operate while in a frozen state.
NEVER bypass any safety feature.
The heater and exhaust piping will be hot during and shortly after use.
Use caution when working in the area around the heater.
800-996-5559
ENGLISH
support@onsenproducts.com
13