onsen ON-I14L-LP Manuel D'installation Et D'utilisation page 6

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

This equipment shall not be operated without the vent pipe properly connected. The exhaust pipe must
not terminate in an area where the exhausting vapor or collecting condensate could create a hazardous
situation or cause property damage. Exhaust gases must be vented out of the building in compliance with
all building codes.
The exhaust piping is very hot during and for a period after use. Do not touch the pipe.
Ensure that snow, ice or other debris does not block the inlet or exhaust pipes.
Regular housekeeping should be done in areas around the heater to prevent insect intrusion and possible
equipment malfunction.
The unit should be serviced on a routine basis to ensure optimum performance. Service needs will vary
based on local water conditions including acidity, alkalinity, hardness, etc.
Freezing temperatures will cause damage to the heater. Install in locations where freezing temperatures are
not reached and follow procedures to drain the unit if it will be out of service for a period of time.
A 120 V / 60 Hz power source should be used. Fire, electrical shock or damage to the water heater may occur
if an incorrect power supply is used.
This appliance is equipped with a three-prong grounded plug for increased protection against electrical
shock. Ensure the plug is properly inserted into a clean, dry outlet that complies with all electrical codes.
Only insert and remove the plug using the plug head and never use a wet hand to plug or unplug the power
plug.
Any alterations to the appliance will void the warranty.
Should overheating occur or the gas supply fails to shut off, turn off the manual gas control valve to the
appliance.
Do not use this appliance if any part has been under water. Immediately call a qualified service technician
to inspect the appliance and to replace any part of the control system and any gas control which has been
under water.
Caution:
Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper
and dangerous operation.
Verify proper operation after servicing.
onsenproducts.com
6
onsenproducts.ca
800-996-5559
support@onsenproducts.com

Publicité

Chapitres

Table des Matières
loading

Produits Connexes pour onsen ON-I14L-LP

Ce manuel est également adapté pour:

On-i14l-ng

Table des Matières