What's Included In The Box - onsen ON-I14L-LP Manuel D'installation Et D'utilisation

Masquer les pouces

Table des Matières

Les langues disponibles

The appliance must be electrically grounded in accordance with local codes. In the event there are no local

codes, the National Electrical Code, ANSI/NFPA 70, or the Canadian Electrical Code, CSA C22.1 shall prevail.

The gas pressure must be between these values: 3.5" W.C. (870 Pa) and 10.5" W.C. (2610 Pa) for natural gas

and 8.0" W.C. (1990 Pa) 13.0" W.C. (3230 Pa) for liquid propane. The gas pressure must not exceed these limits.

The appliance and its individual shut off valve must be disconnected from the gas supply piping system during

any pressure testing of that system at test pressures in excess of ½ psi (3.5 kPa).

The appliance must be isolated from the gas supply piping system by closing its individual manual shut off

valve during any pressure testing of the gas supply piping system at test pressures equal to or less than ½ psi

(3.5 kPa).

The appliance should be located in an area where leakage of the tank or connections will not result in damage

to the area adjacent to the appliance or to lower floors of the structure. When such locations cannot be

avoided, it is recommended that a suitable drain pan, adequately drained, be installed under the appliance.

The pan must not restrict combustion air flow.

Do not obstruct the combustion air intake or heater exhaust and ensure air intake is not near an area that will

allow chemical fumes to enter the combustion air system.

Do not use to heat pools or spas (hot tubs) that use chemically treated water.

If a water heater is installed in a closed water supply system, such as one having a backflow preventer in the

cold water supply line, means shall be provided to control thermal expansion. Contact the water supplier or

local plumbing inspector on how to control this situation.