Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
11a. CONDITIONS
This warranty only covers failures in the lifting tools which is the consequence of production errors
which occur during normal use. The warranty covers no wear to components such as pivots, cam
assemblies, lock springs etc. Should there be any kind of failure within this guarantee period, the
lifting tool will be replaced or repaired to insight of the producer.
No warranty is given to clamps due to the following failures:
-
Regular wear
-
Overload.
-
Wrong and/or carelessly use
-
Damages
-
Not following procedures and measures
-
Hoisting differing material other then indicated on clamp or stated in the user-manual
-
Adapting and/or modifying by REMA.
-
The injudicious use of the clamp, and not succeeding all indications which are stated in the
user's manual.
-
When maintenance and/or revision has not been carried out by REMA.
The producer is not responsible for incidental damage or damage due to use of the lifting tools as
well as from violation of this manual
11b PROCEDURE SAFETY INSPECTION
All inspections and repairing must be written down in the maintenance diagram. This counts not
only for your own inspections but also for inspections which are carried out by REMA. When the
clamp is handed in for maintenance and inspection you always must provide the maintenance
diagram.
Defective Lifting Clamps
When a form of wear or damage is indicated, you must take the following measures.
1. Take the lifting clamp out of use. (Note the date of failure of the lifting clamp)
2. Try to recover the cause of the failure, for example (complete list is available in chapter 1):
-
Overload
-
Wrong and/or carelessly use
-
etc
These claims stated in no.2 do not fall under the guarantee! To guarantee the security of you and
your colleagues you are obliged to follow up this procedure.
3. Return your lifting clamp (with the maintenance history) to your authorised REMA dis
tributor.
4. If the lifting clamp has been revised / repaired by your distributor, you can safely use your clamp
again. Please note this date in your maintenance chart (see page 38).
11c INSPECTION SCHEDULE
Months
Years
Safety inspections by your
own inspector
Maintanance by REMA
Revision by REMA
4
8
12
16
20
1
2
16
24
28
32
36
40
3
44
48
52
56
60
4
5
Publicité
Table des Matières
