Inserting Batteries Into The Remote Control; 9: Setting Up The Receiver Using The Easy Setup - Sony STR-DA5800ES Mode D'emploi

Inserting batteries into the
remote control
Insert two R6 (size-AA) batteries in the
RM-AAU154 remote control.
Observe the correct polarity when installing
batteries.
RM-AAU154
Notes
• Do not leave the remote control in an extremely hot
or humid place.
• Do not use a new battery with old ones.
• Do not mix manganese batteries and other kinds of
batteries.
• If you do not intend to use the remote control for an
extended period of time, remove the batteries to
avoid possible damage from battery leakage and
corrosion.
9: Setting up the receiver
using the Easy Setup
You can set the basic settings of the receiver
easily by operating the receiver in accordance
with the instructions on the TV screen.
Switch the input of the TV to the input to
which the receiver is connected.
When you turn on the receiver for the first
time, the EULA screen appears on the TV
screen. Agree to the EULA to proceed to the
Easy Setup screen, then set up the receiver in
accordance with the instructions on the Easy
Setup screen.
You can set up the following functions using
the Easy Setup.
– Network Settings
– Input Settings
– Home Control Settings
– Speaker Settings
Tip
A check mark will be displayed to the right of any
function items that you have set up.
Notes on Speaker Settings (Auto
Calibration)
Insert the plug of the optimizer microphone all
the way inside the AUTO CAL MIC jack.
Confirm active subwoofer setup
• When a subwoofer is connected, turn on the
subwoofer and turn up the volume prior to
activating the subwoofer. Turn the LEVEL
knob to just before the mid-point.
• If you connect a subwoofer with the
crossover frequency function, set the value
to maximum.
continued
47 US