Preparation 1: Preparing The Receiver And The Remote Control - Sony STR-ZA3000ES Guide De Démarrage

Preparation 1: Preparing the receiver and
the remote control
1
Insert batteries into the remote control.
Batteries
2
Connect the supplied AC power cord (mains lead) to the AC IN
terminal on the receiver firmly, then connect the AC power
cord (mains lead) to a wall outlet.
* Space remains between the plug and the rear panel even when
the power cord (mains lead) is inserted firmly. The cord is
supposed be connected this way. This is not malfunction.
8
US
AC power cord
(mains lead)
(supplied)
*
AC IN terminal
To the wall outlet
3
Press / to turn the AV receiver on.
4
Place the supplied optimizer microphone at ear level about
where you would normally sit.
The optimizer microphone is used for setting the speakers (Auto
Calibration) in step 2 (Easy Setup).
Perform this step after removing the front cover.
Note
Fully insert the plug of the optimizer microphone into the AUTO CAL
MIC jack.
5
Turn the TV on, and then switch the input of the TV to that
which the receiver is connected.