Spare Parts Service; Flow Diagram; Warranty Conditions - Schneider Airsystems MAS 500-10-60 D Notice D'utilisation D'origine

GB
MAS
Problem
I Safety valve blows
out.
J Compressor
heats.
K The oil level rises
without oil having
been added.
L Unusual running
noises.
M The tank for the
water separator
with filter is full of
condensate
2.9

Flow diagram

01 Electric motor
02 Compressor unit
03 Check valve
04 Safety valve
05 Dirt arrester
06 Vessel
07 Pressure gauge (vessel pressure)
08 Pressure reducer
09 Pressure gauge (working pressure)
10 Compressed air connection (cleaned
compressed air)
11 Water separator with filter
12 Compressed
pressed air with oil vapour)
13 Mist oiler
14 Condensate evaporator
15 Throttle (adjustable)
16 3/2-way valve
17 Throttle
18 Pressure switch
(Figure 16a)
II/20
Cause
Vessel pressure is higher than
the set switch-off pressure.
Safety valve is defective.
over- Air supply not sufficient.
Cooling fins on cylinder (cylin-
der head) contaminated.
Duty cycle too long.
Condensate collects in the oil.
High humidity.
V-belt sags.
The float divertor filter element
is dirty.
air connection
Remedy

2.10 Spare parts service

Visit our
tems.com/td/ for the latest version of all ex-
ploded drawings and spare parts lists for our
products. If you have any special questions,
please consult the Schneider Airsystems Ser-
vice centre in your country (addresses in the
service appendix) or your local dealer.

2.11 Warranty conditions

Basis for warranty claims: complete unit
in original condition/proof of purchase.
According to legal provisions, you re-
ceive the following warranty against
material and manufacturing defects:
private use only: 2 years,
(com-
commercial use: 1 year.
Excluded warranty claims: Wear/consum-
able parts; improper use; overload; manipu-
lation/use for other than intended use;
insufficient/incorrect/no maintenance; accu-
mulation of dust/dirt; incorrect/impermissi-
ble work methods; failure to observe the
Instruction Manual; incorrect processing/
working materials; incorrect electrical con-
nection; improper installation.
Have the pressure switch reset/
replaced by a qualified person.
Replace safety valve or contact
service partner.
Ensure sufficient ventilation.
Clean cooling fins on cylinder
(cylinder head).
Switch off compressor.
Compressor is too large, contact
service partner.
Change oil.
Tighten the V-belt
Chap. 2.6.9)
Clean filter element
Chapter 2.6.8)
website www.schneider-airsys-
(see
(see