Water Supply - Danby DWM060WDB Guide D'utilisation Et D'entretien

Installation Instructions

WATER SUPPLY

Water can be supplied to the unit in two different ways depending on what water hook ups are avail-
able to use. Water supply faucets must fi t standard 3/4 inch (19.05 mm) female garden hose cou-
plings. Do not use slip-on or clamp-on connections as the water pressue may cause them to leak.
Using the Quick Connect
If there is only one water supply line available you can use the Quick Connect system to provide wa-
ter to the unit. For a single line installation the Quick Connect should be connected to the cold water
faucet and the inlet hose should be connected to the cold water inlet on the back of the unit.
To attach the Quick Connect to the faucet, follow the steps below:
Hold down the plate of the inlet
hose connector and disconnect
the tap connector from the inlet
hose connector.
Tap
connector
Plate
Inlet hose
connector
If you only have one water supply line (cold or warm water), connect the inlet hose to the cold
1
water connector on the unit. In this situation, you cannot set the wash temperature to hot.
Connect the water inlet hose to the connector by
turning the connecting nut. Be sure a rubber ring
is inside the connecting nut.
Water inlet
hose
Connecting nut
To release, turn off the water faucet and press
the release button on the faucet adapter to re-
lease the water pressure then press down on the
plate.
Screw the tap connector
counter-clockwise onto
the water faucet.
Rubber ring
Plate
Release
button
Hold down the plate and connect
the inlet hose connector to the tap
connector.
Make sure you leave the hot water lid attached.
Do not unscrew the lid of the hot water connec-
tor on the water mixing valve and then connect
the other end of the water inlet hoses to the cold
connector in water mixing valve by turning the
connecting nut.
Hot water
connector
Cold water
connector
Connecting
nut
Water inlet hose
5
Plate
Rubber ring
Lid of hot water
connector