Important; Connecting The Power Cord - Danby DWM060WDB Guide D'utilisation Et D'entretien

Installation Instructions
If you have both cold and hot water supplies, use both supplied inlet hoses to connect the cold
2
water tap to the cold water inlet on the unit and the hot water tap to the hot water inlet on the
unit. In this confi guration you can set the wash temperature to hot or cold.
Connect the water inlet hose to the tap connec-
tor by turning the connecting nut.
Rubber
ring
Connecting nut
To release, turn off the water faucet and turn
on the washer to run about 5 minutes and then
disconnect the inlet hoses.
Note:
1. Do not over tighten or cross thread the nut; the elbow of the water inlet could become damaged.
2. If water seeps, you should check the nut for damage and make sure there is a rubber ring inside
the connection.
IMPORTANT: Ensure that you turn off the water supply before disconnecting the Quick Connect or
inlet hoses.
POSITIONING THE DRAIN HOSE
Connect the drain hose to the water outlet of the washing machine
then fasten it with a hose clamp. Vertical drainage is available only, the
drain hose can be put in the basin or bathtub, as long as the drain hose
range is 0.7 m (70 cm) low to 1.2 m (120 cm) high.

CONNECTING THE POWER CORD

Make sure the power socket is a grounded socket and a 15 amp fuse. Never attempt to disable or
remove the grounding prong of the power plug.
Warning:
• The plug is a 3 prong grounding plug, do not tamper with or modify the plug. If your electrical out-
let is not equipped to take a 3 prong grounded plug, please call a certifi ed technician or electrician
to upgrade your plug outlet.
• Never try and connect the grounding wire of the washing machine with a gas pipe, water pipe, or
any other power cord.
• Do not use if the unit has a damaged power cord.
Note:
• If you open the lid while the machine is running, all operations will be stopped within 7 seconds,
operation will resume when the lid is closed.
• Unplug the power cord if there is a strange noise, smell or smoke coming from the unit. Call for
service.
Unscrew both lids on the water mixing valve, and
then connect the other end of water inlet hoses
to the connectors in water mixing valve by turn-
Water
ing the connecting nut.
faucet
Rubber
ring
Water inlet hose
6
Cold water
connector
Connecting nut
Hot water
connector
Water inlet
hoses