Water Supply - Danby DWM060WDB Manuel Du Propriétaire

INSTALLATION INSTRUCTIONS

WATER SUPPLY

Water can be supplied to the appliance in two
different ways, either through the Quick Connect
assembly or through direct hose connection,
depending on what water hook ups are available
to use. Water supply faucets must fi t standard 3/4
inch (19.05 mm) female garden hose couplings.
Do not use slip-on or clamp-on connections as the
water pressure may cause them to leak.
Using the Quick Connect Assembly
The Quick Connect assembly can be used to provide
water to the appliance when only one faucet is
available. For a single line installation, the Quick
Connect should be connected to the cold water
faucet and the inlet hose should be connected to the
cold water inlet on the back of the appliance.
A breakdown of the Quick Connect assembly is
below.
1
2
3
4
1. Faucet Adapter
2. Locking Collar
3. Inlet Hose Connection
4. Drain Hose Connection
5. Pressure Release Valve
6. Quick Connect Assembly
Note: The drain hose connection on the Quick
Connect assembly is only for use with counter top
dishwashers. When using the Quick Connect with a
portable dishwasher or washing machine, leave the
cap in place, this connection is not necessary.
All manuals and user guides at all-guides.com
5
6
Connecting the Quick Connect Assembly to the
Water Supply
Pull down on the locking collar and pull up on the
faucet adapter to remove the adapter from the
assembly.
Remove the aerator from the faucet before attaching
the faucet adapter.
If the water supply faucet is female threaded, (left
image below), use both the thick and thin washers
in the connection.
If the water supply faucet is male threaded,
(right image below), use the thick washer in the
connection.
Turn on the faucet to check for leaks at the
connection before continuing. If leaks are present,
it may be necessary to wrap the faucet adapter or
the faucet with Tefl on tape before connecting the
adapter to the faucet.
Pull down on the locking collar and push the Quick
Connect assembly onto the bottom of the faucet
adapter. Release the locking collar to attach the
Quick Connect to the faucet.
5