Connecting The Water Supply Hose; Important - Danby DWM17WDB Guide D'utilisation Et Soins De Propriètaire

Installation Instructions
INSTALLING A NOISE
PROOF PLATE
Take the noise proof
plate out of the
package .
CONNECTING THE
WATER SUPPLY HOSE
WATER FAUCET
Water supply faucets must fit standard 3/4 inch (19.05mm)
female garden hose couplings. Do not use slip-on or clamp-on
connections.
Note: Refer to section on water supply requirements before connecting water inlet hoses.
If you just have one water supply line (cold or warm water), connect the inlet hose to the cold water
1
connector on the water mixing valve.
In this situation you can not set the wash temperature to hot.
Hold down the plate of the inlet hose
connector and disconnect the tap
connector from the inlet hose
connector.
Tap
Connector
Plate
Inlet hose
connector
The opening of the
noise proof plate is
at the bottom of
the machine.

IMPORTANT

Screw on the tap connector counter
clockwise.
Insert the noise proof
plate into the washing
machine base.
Standard 3/4 Inch
6
Lay down the machine
and secure the noise
proof plate by fastening
the two set screws.
Hold down the plate and connect
the inlet hose connector to the tap
connector.
Plate