Connecting The Water Supply Hose - Danby DWM045WDB Guide D'utilisation Et D'entretien

Installation Instructions
INSTALLING A NOISE PROOF PLATE
Take the noise proof plate
out of the package.

CONNECTING THE WATER SUPPLY HOSE

WATER FAUCET
Water supply faucets must fi t standard 3/4 inch (19.05mm) female garden hose
couplings. Do not use slip-on or clamp-on connections.
Note: Refer to section on water supply requirements before connecting water inlet hoses.
If you just have one water supply line (cold or warm water), connect the inlet hose to the cold water connector on
1
the water mixing valve.
Hold down the plate of the inlet hose
connector and disconnect the tap con-
nector from the inlet hose connector.
Tap con-
nector
Plate
The opening of the noise
proof plate is at the bot-
tom of the machine
In this situation, you cannot set the wash temperature to
hot.
Screw on the tap connector count-
er-clockwise.
Inlet hose
connector
Insert the noise proof
plate into the washing
machine base
IMPORTANT
5
Lay down the machine
and secure the noise
proof plate by fastening
the two (2) screws.
Standard 3/4 Inch
Hold down the plate and connect the
inlet hose connector to the tap con-
nector.
Plate