Danby DWM045WDB Guide D'utilisation Et D'entretien page 9

Installation Instructions
CONNECTING THE WATER SUPPLY HOSE
Connect the water inlet hose to the connector by turning
the connecting nut. Be sure a rubber ring is inside the
connecting nut.
Water in-
let hose
Connect-
ing nut
To release, turn off the water faucet and press the release
button to release the pressure of water then press down
the plate.
If you have both cold and hot water supplied, connect the inlet hoses cold to cold and hot to hot.
2
Connect the water inlet hose to the tap connector by
turning the connecting nut.
Rubber
ring
Connect-
ing nut
To release, turn off the water faucet and turn on the
washer to run about 5 minutes and then disconnect the
inlet hoses.
Note:
1. Do not over tighten or cross thread the nut in order to prevent the elbow of the water inlet from breaking.
2. If water seeps, you should check the nut for damage and make sure there is a rubber sealed ring.
Rubber
ring
Plate
Release
button
Water
faucet
Water in-
let hose
Make sure you leave the hot water lid attached. Do not
unscrew the lid of the hot water connector on the water
mixing valve and then connect the other end of the water
inlet hoses to the cold connector in water mixing valve by
turning the connecting nut.
Hot water
connector
Cold water
connector
Connect-
ing nut
Water in-
let hose
Unscrew both lids on the water mixing valve, and then con-
nect the other end of water inlet hoses to the connectors in
water mixing valve by turning the connecting nut.
Cold water
connector
Rubber
ring
Connect-
ing nut
6
Rubber
ring
Lid of hot wa-
ter connector
Hot water
connector
Water in-
let hose