Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION INSTRUCTIONS
LOCATION
• Two people should be used when moving the
appliance.
• Remove interior and exterior packaging prior
to installation. Remove the shipping brace and
save it to prevent damage to washer components
whenever washer is moved or transported to
a new location. The shipping brace is a small
plastic brace that is adhered to the packing
Styrofoam.
• Wipe the outside of the appliance with a soft,
dry cloth and the inside with a lukewarm wet
cloth. Do not spray the appliance with water.
• Place the appliance on a level fl oor that is strong
enough to support it when it is fully loaded,
in a room that has convenient access to a
water supply and drain, has low moisture and
humidity and does not freeze in winter.
• Do not place the appliance on carpeted fl ooring
as this can block the lower ventilation openings.
• Keep the appliance away from heat sources and
out of direct sunlight. Excessive heat or sunlight
can deform or discolour the appliance.
• This appliance is intended for household use
only. It is not designed for outside installation,
including anywhere that is not temperature
controlled (garages, porches, vehicles, etc.).
• This appliance is 54.5 cm (21.5 inches)
wide by 95 cm (37.4 inches) high by 55 cm
(21.7 inches) deep. Make sure that you leave
the minimum amount of space between the
appliance and all surrounding walls and vents.
• Allow 12.7 cm (5 inches) of space between the
back, sides and top of the appliance and all
adjacent walls.
• This appliance is intended for free-standing
installation only and is not intended to be
built into a cabinet or counter. Building in this
appliance can cause it to malfunction.
• Do not use excessively hot water in the
appliance, 50°C (122°F) or more. Plastic parts
and clothing may be deformed or damaged.
All manuals and user guides at all-guides.com
FEATURES
1. Detergent Case
2. Filter Assembly
3. Pulsator
4. Control Panel
5. Noise Proof Plate
6. Adjustable Foot
7. Drain Hose
8. Power Supply Cord
9. Inlet Hoses
LEVELING INSTRUCTIONS
It is important that the appliance is level to help
avoid unbalanced loads and excessive noise.
1. Turn the leveling foot counter-clockwise until
2. Slowly turn the leveling foot clockwise until the
Note: This appliance includes one adjustable foot
on the front, three solid feet and two rollers on the
back to aid in moving the appliance from place to
place.
3
1
2
3
4
5
6
the top of the foot is touching the bottom of the
cabinet.
appliance is level.
9
8
7
Publicité
Table des Matières
