Start / Stop / Reverse Function; Procedure To Stop The Machine; Locking - Unlocking The Hand Control Setting; Possible Values For Each Parameter - Kinetec Maestra Manuel D'utilisation

12.2.

START / STOP / REVERSE function

As with all KINETEC
Press the
Press the
For optimum safety, always give the hand control to the patient before starting the system.
12.3.

Procedure to stop the machine

To stop the machine's movement: press the
To switch the unit off: press the ON / OFF switch (3) (see page 5)
12.4.

Locking - Unlocking the hand control setting

The hand control allows the patient to control the machine as appropriate.
Simultaneously press the
The display reads LOCK, you cannot change the parameters; if you try the message
LOCK will be displayed. The Start and Stop keys are still active.
To unlock the hand control, simultaneously press the same keys. The display will show UNLOCK.
We recommend that you lock the hand control when you give it to the patient.
Note: the hand control lock is cancelled when you switch the unit ON/OFF.
12.5.

Possible values for each parameter

-90°
• Lower limit
90°
• Upper limit
• Speed
• Force
• Extension pause
• Flexion pause
• Timer
Default setting values for each parameter
-10°
• Lower limit
10°
• Upper limit
• Speed
• Force
• Extension pause
• Flexion pause
• Timer
Kinetec Maestra™
systems, the device Kinetec Maestra™ is equipped with a START/STOP/REVERSE function.
®
key of the hand control, the movement stops,
key of the hand control, the movement starts in the opposite direction.
&
1 press 2 press
st nd
-50° -50°
90° 140°
1 press 2 press
st rd
-20° 0°
20° 60°
CAUTION
key
keys to lock the hand control.
3 press
rd
-30° 0°
60° 180°
1 to 9 (from 150° to 440° per minute)
1 to 6
0 to 900 seconds (15 minutes)
0 to 900 seconds (15 minutes)
No timer (00H00) to 24H00
3 press
rd
0° 0°
40° 90°
2
6
0
0
0
EN
1 press 2 press
st nd
-30° 0° 0°
225° 90° 180°
1 press 2 press
st rd
0° 0° 0°
50° 40° 90°
3 press
rd
0°
70°
3 press
rd
0°
40°
6 / 23