Ingeteam INGEREV CITY Duo Manuel D'installation Et Usage page 39

INGEREV CITY Duo
5. Connect the wiring that joins the control card to the communications card (see Cable E, light grey cabling in
the following figure). Then connect the cable that joins the communications card with the USB modem (F).
To wire the communications card and control card at the station, you must keep in mind the following
connection positions:
The jumper of the communications card, marked as G in the previous figure, remain in place.
ABA2017IQM01_A - Installation and Operation Manual
Pin Colour
1 White/Orange
2 Orange
F
E
G
Signal
RS-485 B (+)
RS-485 A (–)
Ingeteam
EN
ES
FR
IT
39