Ingeteam INGEREV CITY Duo Manuel D'installation Et Usage page 21

INGEREV GARAGE
Remove the end of line jumper from the control card and connect the charging station to the next station
of the communication ring (dark grey cable in the figure below).
2. Connect the wiring that joins the control card to the communications card (see the light grey cabling in
the following figure).
Connect the modem to the communications card (see the white cable in the figure below).
The jumper of the communications card must remain in place.
ABA2017IQM01_A - Installation and Operation Manual
Control card jumper
Pin Colour
1 White/Orange
2 Orange
Communications card jumper
Control card jumper
Signal
RS-485 B (+)
RS-485 A (–)
Ingeteam
EN
ES
FR
IT
21