Ingeteam INGEREV CITY Duo Manuel D'installation Et Usage page 23

INGEREV GARAGE
Remove the end of line jumper from the control card and connect the charging station to the next station
of the communication ring (dark grey cable in the previous figure).
2. Connect the wiring that joins the control card to the communications card (see the light grey cabling in
the following figure).
Connect the USB modem to the communications card to obtain the GPRS/3G connection (see the white
cable in the figure below).
The jumper of the communications card must remain in place.
ABA2017IQM01_A - Installation and Operation Manual
Pin Colour
1 White/Orange
2 Orange
Signal
RS-485 B (+)
RS-485 A (–)
Modem
Communications
card jumper
Ingeteam
EN
ES
FR
IT
23