Cleaning The Water Tank; Changing The Battery Of The Remote Control - DeLonghi EV250 Mode D'emploi

Masquer les pouces Voir aussi pour EV250:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

4.2 Cleaning the water tank

Please note:
Turn off unit and let sit two minutes before removing drawer to
allow excess water to drain back into tank
Remove the water tank (fig. 4);
Clean thoroughly with a cleaning sanitizer, easily available
in stores (fig. 20).

4.3 Changing the battery of the remote control

Remove the battery holder on the back of the remote con-
trol (fig. 21);
Insert one 3V CR2025 type lithium battery on the support,
checking that the polarity is correct (+ and -) (fig. 22).
Please note:
20
21
22
9
If you change or dispose the remote control, the bat-
tery must be removed and disposed of according to local
recycling regulations.
Never throw the battery in fire as it may explode or leak
dangerous liquids.
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reaso-
nable protection against harmful interference in a residen-
tial installation.
This equipment generates, uses and can radiate radio fre-
quency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or
television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
- Connect the equipment into an outlet on a circuit differ-
ent from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician
for help.
Changes or modifications not expressly approved by the
party responsible for compliance could void the user's au-
thority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Ope-
ration is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
This Class B digital apparatus complies with Canadian
ICES-003.

Publicité

Table des Matières
loading

Table des Matières