Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3. REFILLING THE WATER TANK
Please note:
Turn off the unit and let sit two minutes before removing drawer
to allow excess water to drain back into tank.
Always check that there is water in the water tank before using
the Cooler/Humidifying function. If the water finishes in the
tank during use, the appliance emits a beep and the symbol fla-
shes (fig. 15): the appliance continues with the function.
1. Remove the water tank (fig. 4) and fill with MAX 4.5L
(152oz) of fresh tap water only (do not overfill the water
tank: see water level indicator A2);
2. Put the tank back in the appliance.
4. CLEANING AND MAINTENANCE
•
Always unplug the appliance before cleaning.
•
Never immerse the appliance in water.
•
Pouring water on the unit is strictly forbidden (fig. 16).
•
Do not use benzine, alcohol or solvents for cleaning.
•
Do not spray insecticide liquid or similar since the plastic
could be deformed.
•
Clean the surface of the unit with a damp cloth, never use
an abrasive scourer directly on the outside surface as it
might scratch.
MAX
MIN
15
16
4.1 Cleaning the dust filter and the cooling pad
To avoid clogging of the dustproof filter, please clean the filter
regulary. The frequency of cleaning is to be related to the wor-
king time: if used daily, it is suggested to clean filter weekly.
•
Remove the dust filter and cooling pad (fig. 17);
•
Remove the dust from the filter and the cooling pad using a
vacuum cleaner (fig. 18);
•
Wash thoroughly the cooling pad with water; then leave it
to completely dry and reassemble the filters in its housing
(fig. 19).
•
To maintain the efficiency of the appliance, it is suggested
to change the cooling pad every year.
8
17
18
19
Publicité
Table des Matières
