Operating From The Control Panel; Turning The Appliance On; Air Conditioning - DeLonghi PAC AN HPE Série Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

For help with installation, operation, and for all
accessories and spare/replacement parts, please contact
our toll free customer service call center at:
1-800-322-3848 [US only]
1-888-335-6644 [Canada only]
01-800-711-8805 (Mexico only]
or log onto our website at www.delonghi.com

OPERATING FROM THE CONTROL PANEL

Note:
Before plugging the appliance check the caps on the
back of the unit are correctly inserted and screwed
on the drainage hose A10.
Never turn the air conditioner o by unplugging from the
outlet. Always press the
minutes before unplugging. This allows the appliance to
perform a cycle of checks to verify operation.

TURNING THE APPLIANCE ON

10
°F
11
Press the MODE button (B2) until the light corresponding to the
desired mode lights up:
Air conditioning symbol (B7)
Dehumidifying symbol (B8)
°F
12
8
button, then wait for a few
Plug
into
the
electrical
receptacle. Two lines appear on
the display indicating that the
appliance is in stand-by ( g. 10).
Press the
button (B1).
The rst time the appliance
is turned on, it will be in air
conditioning
mode.
temperature will be displayed
and fan speed will be at
minimum ( g. 11). When turned
on subsequently it will be in the
same mode as when last turned
o .
Heating symbol (B9)
Fan symbol (B10)

AIR CONDITIONING

Ideal for hot muggy weather when you need to cool and
dehumidify the room.
To set this function correctly:
Press the MODE button a number of times until the air
conditioning symbol appears. Room temperature is
displayed ( g. 11).
9
After 10 seconds, room temperature is displayed again.
Select the required fan speed by pressing the
There are 3 speeds available:
High speed: to achieve the target temperature as rapidly
as possible;
Medium speed: reduces noise levels but still maintains a
good level of comfort;
Low speed: for silent operation.
The most suitable indoor temperature for the room during
the summer varies from 75°F to 81°F (24 to 27°C). You are
recommended, however, not to set a temperature much below the
outdoor temperature.
Note:
When installing the air conditioner, you should leave a door sli-
ghtly open little as 1/2" (1 cm) to guarantee correct ventilation
and room pressure.
DEHUMIDIFYING
Ideal to reduce room humidity (spring and autumn, damp ro-
oms, rainy periods, etc). For this mode, the appliance should be
prepared in the same way as for air conditioning, with the air
exhaust hose attached to enable the moisture to be discharged
Room
outside.
is adjustable. If the temperature is below, fan speed is selected au-
tomatically by the appliance and cannot be set manually.
7
10
°F
11
• Select the target tempera-
ture by pressing the
button (B6) or
ton (B3) until the required
°F
value is displayed. During
selection, the temperature
12
ashes ( g. 12).
°F
13
10
°F
14
°F
11
°F
12
To set this function correctly:
• Press the MODE button a
number of times until the
dehumidifying symbol ap-
°F
pears ( g. 13).
In this mode, with room tempe-
13
°F
rature above 77 °F, the fan speed
17
°F
14
but-
button.

Publicité

Table des Matières
loading

Table des Matières