Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
12
HEATING MODE
This is ideal in spring and autumn when outdoor temperatures
are not particularly severe.
°F
For this mode, the appliance should be prepared in the same
way as for air conditioning, with the air exhaust hose attached to
10
13
enable the moisture to be discharged outside.
°F
°F
11
14
High speed: to achieve the target temperature as rapidly
as possible
°F
Medium speed: reduces noise levels but still maintains a
good level of comfort
12
Low speed: for silent operation
With particular room conditions (e.g. low temperature or high
temperature), the appliance will automatically select the opera-
ting fan speed however, If the unit is cold, it will automatically per-
°F
form a pre-heating cycle. It can take several minutes and fan will
not operate until pre-heating cycle is over. In this mode, the fan
13
may operate for short periods, even though the set temperature
has already been reached.
FAN MODE
When using the appliance in this mode, the air exhaust hose
°F
°F
does not need to be attached.
17
14
To set this function correctly:
Press the MODE button (B2) a number of times until the fan
•
symbol
appears.
•
Select the required fan speed by pressing the
(B5).
18
°F
°F
High speed: for maximum fan power ( g. 15);
19
°F
17
To set this function correctly:
• Press the MODE button a
number of times until the
heating symbol
( g. 14).
• Select the required fan
speed by pressing the
button (B5).
°F
15
Medium speed: reduces
noise levels but still maintains a
good level of comfort ( g. 16);
Low speed: for silent
operation ( g. 17).
To change the unit of measurement for the displayed temperature,
press the
and
SETTING THE TIMER
The timer can be used to delay when the appliance comes on or
goes o . This avoids wasting electricity by optimising operating
periods.
How to programme delayed start up
appears
•
Use the
of hours delay before the appliance comes on. They increase
or decrease the time in steps of an hour.
The appliance can be set to come on within the next 24 hours.
Five seconds after the timer has been set, the display dims and
the setting is memorised.
After setting, the operating mode and fan speed can be modi ed.
To cancel the timer programme, press the timer button (B4)
again. Pressing the ON/OFF button (B1) cancels the timer pro-
gramme and the air conditioner comes on immediately in the
selected mode.
How to programme delay OFF
button
•
Use the
of hours delay before the appliance goes o .
They increase or decrease the time in steps of an hour.
The appliance can be set to go o within the next 24 hours.
Five seconds after the timer has been set, the operating mode is
displayed and the timer symbol remains on.
16
At the set time, the air conditioner goes o and remains in
stand-by.
To cancel the timer programme, press the timer button (B4)
again. The timer symbol goes o .
After setting, the operating mode and fan speed can be modi ed.
8
°F
buttons together for 3 seconds.
14
°F
17
• Plug the appliance into an
electrical receptacle. It will
be in STAND-BY.
• Press the timer button (B4).
The timer symbol (B16)
comes on ( g. 18).
18
(B6) or
(B3) buttons to set the number
°F
°F
19
17
18
• Delay OFF can be pro-
grammed in any operating
mode - air conditioning/fan/
dehumidifying.
°F
• Press the timer button (B4).
19
The timer on symbol (B16)
comes on ( g. 19).
(B6) or
(B3) buttons to set the number
Publicité
Table des Matières
