Technical Specification - DeLonghi PAC AN HPE Série Mode D'emploi

20
action. It also greatly reduces concentrations of irritants such as
pollen and spores.
Start of season checks
Make sure the power cable and plug are undamaged and
the ground connection is e cient. Follow the installation
instructions precisely.
End of season operations
Clean the lter and dry thoroughly before putting back.
In order to properly storage the appliance at the end of the
season, we suggest you cover it with the supplied end of season
dust cover C9 and you put the accessories in the relevant end of
season accessories bag C10.

TECHNICAL SPECIFICATION

Power supply voltage
Max. absorbed power
during air conditioning
Max. power input during heating
Refrigerant
Cooling capacity
LIMIT CONDITIONS
Room temperature for air conditioning
(with fan at maximum speed)
Room temperature for
heating
Use a vacuum cleaner to remove
the dust collected on the lter. If
it is very dirty, immerse in warm
water and rinse a number of ti-
mes. The water should never be
hotter than 104°F ( 40°C).
After washing, leave the lter
to dry. Put the lter back in its
housing.
The silver ion lter not just
retains dust particles, but also
has an e cient antibacterial
To drain all water from the
circuit, remove the external
cap by unscrewing it in the
anticlockwise direction then,
remove the internal cap from
the drain hose on the back of
the appliance and allow the
water to drain out into a basin
( g. 21).
When the appliance is empty,
21
replace the caps.
see rating label
"
"
"
"
64 ÷ 104°F - 18 ÷ 40°C
50 ÷ 77°F - 10 ÷ 25°C
Transport, lling, cleaning, recovery and disposal of
refrigerant should be performed by a technical service
centre appointed by the manufacturer only.
The appliance should be disposed of by a specialist centre
appointed by the manufacturer only.
TO AVOID DAMAGE TO THE UNIT:
NEVER TRANSPORT OR TURN THE APPLIANCE UPSIDE DOWN OR
ON ITS SIDE. IF THIS OCCURS, WAIT 6 HOURS BEFORE TURNING
THE APPLIANCE ON, 24 HOURS IS RECOMMENDED. After the unit
has been on its side, oil needs to return to the compressor to en-
sure proper function. Without allowing the unit this time (6-24
hours) the unit may function for only a short time, and then the
compressor will break down from lack of oil.
CHARACTERISTICS OF THE PLUG
This appliance is equipped with a 3 prong grounded plug. The
plug must be connected into an outlet that is properly installed
and grounded in the accordance with all local codes and ordi-
nances. Do not modify the plug provided with the appliance.
If it will not t the outlet, have a proper outlet installed by a
quali ed electrician or relocate the unit to a proper outlet. If the
household electrical supply does not meet the above speci ca-
tions, or if you are not sure your home has an e ective electrical
ground, have a quali ed electrician or your local electrical utility
company check it and correct any problems.
SAFETY PLUG
The appliance is tted with a safety plug to protect the power
cable.
If power is cut o , unplug from the outlet and make sure the
power cable is undamaged.
If the cable is damaged, call the service center immediately.
If power cuts o frequently and the power cable is undamaged,
contact a quali ed electrician.
OPERATION OF THE SAFETY PLUG
If the safety device incorporated in the plug trips and cuts o
the power supply, check that the power cable and plug are not
damaged.
If the power cable is undamaged, to restore operation press the
"RESET" button.
To verify correct operation of the plug, press the "TEST" button
periodically and make sure the appliance disconnects. If this is
not the case, contact the service center.
To restore operation, press the "RESET" button.
11