Operating From The Remote Control; Inserting Or Replacing The Batteries - DeLonghi PAC AN HPE Série Mode D'emploi

OPERATING FROM THE REMOTE CONTROL

Using the remote control
• Point the remote control at the receiver on the air
conditioner. The remote control must be no more than
16,4ft (5 meters) away from the appliance (without
obstacles between the remote control and the receiver).
Description of the remote control (D)
D1) "ON/OFF" button
D2) Increase/Decrease button for temperature/programmed
use
D3) "MODE" button
D4) "TIMER" button
D5) °F/°C scale button
D6) Fan speed selection button (MAX/MED/MIN)
D1
D6
D5

Inserting or replacing the batteries

• Remove the cover on the rear of the remote control;
• Remove the old batteries, if present.
• Correctly insert two new L03 "AAA" 1,5V batteries (see the
instructions inside the battery compartment);
• Replace the cover.
If the remote control unit is replaced or discarded, the
batteries must be removed and disposed of in accordan-
ce with current legislation as they are harmful to the
environment. Do not mix old and new batteries. Do not
mix alkaline, standard (carbon-zinc) or rechargeable (ni-
ckel-cadmium) batteries. Do not dispose of batteries in
re. Batteries may explode or leak. If the remote control
will not be used for a certain length of time, remove the
batteries.
MAX 16 ft
MAX 5 meters
D2
D3
D4
Note: This equipment has been tested and found to
•
comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference
in a residential installation.
• This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment o and on, the user
is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment
and receiver.
- Connect the equipment into an outlet on a
circuit di erent from that to which the receiver
is connected.
- Consult the dealer or an experienced radio/TV
technician for help. Changes or modi cations
not expressly approved by the party responsible
for compliance could void the user's authority to
operate the equipment.
• This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
• This Class B digital apparatus complies with Canadian CAN
ICES-3 (B) / NMB-3 (B).
Turning the appliance ON
Plug the appliance into the the electrical receptacle.
Press the ON/OFF button (B1) (when turned on, the air condi-
tioner starts operating in the same mode as when it was turned
o ).
Press the MODE button (B2) to select the required mode
COOLING
DEHUMIDIFYING
HEATING
FAN ONLY
On the control panel, the light corresponding to the selected
mode comes on.
For air conditioning/dehumidifying/heating/fan only settings
and programming the timer, see the relative paragraph.
9