Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
SELF-DIAGNOSIS
The appliance has a self diagnosis system to identify a number of warning/malfunctions.
Error messages are displayed on the appliance display.
IF ... IS DISPLAYED,
"Low Temperature"
(Frost prevention)
..WHAT SHOULD I DO?
The appliance is fitted with a
frost protection device to avoid
excessive formation of ice. The
appliance starts up again auto-
matically when the defrosting
process is completed.
TIPS FOR CORRECT USE
To ensure optimal results from your air conditioner, follow these
recommendations:
•
Close the windows and doors where air conditioner will be
used. When installing the air conditioner semi-permanent-
ly, you should leave a door slightly open (as little as 0,39
inches - 1 cm) to guarantee proper ventilation.
•
Never use the appliance in very damp rooms (laundries for
example).
•
Protect the room from direct exposure to the sun by par-
tially closing curtains and/or blinds to make the appliance
much more economical to run.
•
Never use the appliance outdoors.
•
Make sure there are no heat sources in the room.
•
Make sure the air conditioner is standing on a level surface.
•
Never rest objects of any kind on the air conditioner.
•
Never obstruct the air intake or air outlet flap (see fig.
below).
do not cover the appliance
IF ... IS DISPLAYED,
"Probe Failure"
(Probe damaged)
..WHAT SHOULD I DO?
If this is displayed, call center
information
IF ... IS DISPLAYED,
"High Level"
(Internal tray full)
..WHAT SHOULD I DO?
Empty the internal safety tank
following the instructions in the
section "End of
season operations"
CLEANING
Before cleaning or maintenance, turn the appliance off by
touching the
button, then unplug from the outlet.
CLEANING THE APPLIANCE
You should clean the appliance with a slightly damp cloth then
dry with a dry cloth. For safety reasons, never wash the air con-
ditioner with water.
Attention! Never use petrol, alcohol or solvents to clean the ap-
pliance. Never spray insecticide liquids or similar.
CLEANING THE BIO SILVER AIR FILTER
The BioSilver filter helps capture dust and pollen and helps re-
duce the growth of bacteria and mold on the filter.
If the filter is dirty, air circulation is compromised and the effi-
ciency of the appliance decreases. It is therefore good practice
to clean the filter at regular intervals. The frequency depends
on the duration and conditions of operation. If the unit is used
constantly or systematically, you are recommended to clean the
filter once a week. The filter is housed in the intake grille.
To clean the filter, extract as shown in fig. 9.
12
IF ... IS DISPLAYED,
"Communication Failure"
(Internal communication
issue)
..WHAT SHOULD I DO?
If this is displayed, contact your
local authorized service center.
9
Publicité
Table des Matières
