Practical Advice; Maintenance And Service; Maintenance And Cleaning - Bosch PLS 300 Notice Originale

16 | English

Practical Advice

The following tips are for performing length or mitre cuts (90°/45°).
Problem
Cut runs out of centre
Wood surface unsatis-
factory after cut
For working instructions and practical advice on
the PLS 300 saw station, log onto:
www.bosch-do-it.com/pls300

Maintenance and Service

Maintenance and Cleaning

If the saw station should fail or become dam-
aged despite the care taken in manufacture and
testing, repair should be carried out by an au-
thorised customer services agent for Bosch
power tools.
1 609 929 S38 | (15.9.09)
Cause
Guide rail 4 not affixed
Saw blade too thin
Sawing feed too high (apply less
feed with power tool)
Angle adjustment of base plate to
saw chain incorrect
Saw blade does not run in guide
roller (see figure F)
Workpiece was sawn with the
visible side facing up
Saw blade worn
Sawing feed too high (apply less
feed with power tool)
Sawing was carried out with orbit-
al action switched on
Corrective Measure
Affix guide rail according to height of
workpiece; provide for firm clamping
of the workpiece
Use the provided saw blade T144DP
Saw through workpiece applying less
and uniform feed
Do not apply pressure against the
side stops 5
Align base plate to saw chain and
retighten
Adjust guide roller in such a manner
that the saw blade is guided
(see operating instructions of the jig-
saw)
Saw workpiece with the visible side
facing down (see figure A3)
Insert new saw blade
Saw through workpiece applying less
and uniform feed
Do not apply pressure against the
side stops 5
Switch orbital action off
For further questions, please refer to our cus-
tomer hotline:
Great Britain
Tel: +44 (0844) 736 0107
Australia, New Zealand
Phone: +61 (01300) 307 044
In all correspondence and spare parts orders,
please always include the 10-digit article
number given on the type plate of the saw sta-
tion.
Bosch Power Tools