Startup; Energy Control - Broncolor Mobil A2R Mode D'emploi

1. startup

1.1 Battery operation
1.1.1 startup
remove protective cardboards from battery contacts before use.
Use the switch "on/off" (1) to power up the unit and check the display "charge state" (17). if the
stored energy of the battery is less than 10 % it must be charged by means of the charger (charging
time approx.  hours for approx. 90 % of charge) or change to another battery. before powering up
the unit for the first time, it is recommended to charge the battery.
1.1.2 changing the battery
Switch off the unit before changing the battery.
Please check the contact surfaces of the battery for soiling to guarantee a good contact. Prior to
inserting the battery ensure that the side with the contacts is directed towards the opening of the
power pack compartment.
now slide the battery into the power pack compartment and fasten it by firmly pushing down
the power pack, from the top, onto the battery which is standing on the floor. Make sure that the
contact springs in the battery compartment are not dirty or damaged. When changing the battery
press the locking mechanism at the bottom () together using finger and thumb. The two big
contact springs slide the battery out so far that the user may grip it.
attention! to prevent accidents and damage to the battery, make sure that the battery
completely locks into place. Lift the power pack with caution and check that it is correctly
fitted.

2. energy cOntrOL

2.1 mobil a2r
Use the "up/down" keys (6) to control the flash energy within a range over 4 f-stops. A value of 10
in the display indicates maximum energy, 6 minimum. Whole numbers are full f-stop intervals,
decimals indicate 1 / 10 f-stop steps. brief pressure on the "up/down" keys (6) runs the power up
(or down) by a 1 / 10 f-stop interval, prolonged pressure by a full f-stop. The display (7) then blinks
until charging or discharging has stabilized the new level.
Three different power output distributions (10) are available when  lamps are connected:
50 / 50 %, 70 / 0 % and 80 / 0 %. They can be altered with the key "up/down" (11).
8