Release; Flash Ready Signals Visual / Audible - Broncolor Mobil A2R Mode D'emploi

4. reLease

4.1 photo cell (cell) and infrared receiver (ir)
The photo cell can be switched on or off by using the "cell" key (16), the infrared receiver by using
the "ir" key (15). if they are activated the green lED lights up.
4.2 infrared flash release channel
Mobil power packs can be triggered with broncolor infrared transmitters. if the power pack is trig-
gered via infrared, the flash release follows with a time delay of 1 / 1000 s. The power pack can be
triggered as soon as 100 % of the charge are reached.
4.3 sync socket
Synchronous cables art. no. 4.111.00 or 4.11.00 may be plugged into the socket () to release
flashes via cable.
4.4 "test" key
Key (1) allows the power pack to be manually released.
4.5 radio signal receiver
With Mobil Ar units, the radio signal receiver can be switched on and off (5). if this one is acti-
vated the green lED lights up.

5. fLash ready signaLs visuaL / audiBLe

5.1 the visual ready signal
is the green lED (1) at the "test" key (1). it lights up only when the unit is fully charged. After a
flash this lED goes out and lights up again when the unit is fully charged once more.
5.2 the audible signal (buzzer)
sounds when the power capacitors are at 100 % charge. it may be switched on or off. This is
explained in chapter 6..
5.3 audible alarm signal
When the flash discharge fails, an audible warning signal of approx.  s duration will sound.
10