Broncolor Mobil A2R Mode D'emploi page 6

The flash light equipment is designed for use in dry conditions and in an ambient temperature
>
from 0°c to 5°c! The flash light equipment has to be protected from wetness, condensation, from
dripping and splash water, humidity, dirt, sand, metal chips and exposure to dust!
Protect the flash light equipment from electromagnetic fields, shock and vibration!
>
Protect the flash light equipment from heat and frost! if the power pack freezes continuous loss of
>
power output and serious technical damage can result!
To prevent accidents, make sure that the battery completely locks into place. lift the power pack
>
with caution.
Sudden temperature differences can cause condensation water in the unit! in such situations the
>
equipment must stay for 1 hour in a well ventilated place to acclimatise to the new temperature
before startup!
Do not operate the units in an environment where there is a risk of explosion!
>
The power pack and the lamps should not be operated in or near water! Attention: high voltage!
>
The power pack and the lamps should not be immersed in water or other liquids! it could cause
>
an electric shock!
remove the transport protection cap on the front side of the lamp and any foam plastic before
>
connecting it to the power pack!
For safety reasons, never operate the lamp without the protecting glass in place! UV-coated pro-
>
tecting glasses or UV-coated flash tubes must be utilised as a protection against UV radiation for
eyes and skin!
before operation the lamp has to be fastened on a stand or a suspension device! The lamp must
>
be locked by tightening the mounting screw!
only sand-filled fuses of the type indicated on the safety type plate may be used! Sand-filled fuses
>
can be identified by their opaque fuse body! With incorrect fuse protection the halogen lamp may
burst!
Filters or diffusors should not be fastened directly on the flash tube, halogen modelling lamp or
>
protecting glass!
Do not operate appliance with a damaged earthed cable. cables which are damaged or twisted
>
must be replaced!
The battery must only be charged on an earthed socket, or an emergency power generator!
>
if an extension cable is necessary, a cable with a current rating at least equal to that of the ap-
>
pliance should be used. cables rated for less amperage than the appliance may overheat. When
using a cable reel, it must be completely unrolled before use to prevent overheating of the cable!
Do not operate the unit inside a bag or any kind of container!
>
The ventilation slits on the unit or on the lamp should not be covered!
>
Pay attention when laying, clearing away or rolling up cables that they do not contact hot surfaces
>
or parts of lamps and that they will not be tripped over by persons!
5