Specifications - Sony MDS-NT1 Mode D'emploi

The Net MD lamp flashes.
• If the other indicators are lighted up or
flashing, the MD deck's self-diagnosis
function is active. See the table on page 12.
• When the other indicators are off, you have
pressed the inoperative N/> button while
OpenMG Jukebox is active. Only the x/Z
button for ejecting the MD can be operated at
this time.
Note
If the deck does not operate properly even after
you've attempted the prescribed remedies, eject the
MD, then reinsert the AC power adaptor into the AC
power outlet.

Specifications

System MiniDisc digital audio system
Disc MiniDisc
Laser Semiconductor laser (λ = 780 nm)
Emission duration: continuous
Revolutions (CLV) 800 rpm to 1800 rpm
Error correction Advanced Cross Interleave Reed
Solomon Code (ACIRC)
Sampling frequency 44.1 kHz
Coding Adaptive Transform Acoustic
Coding (ATRAC)/ATRAC 3
Modulation system EFM (Eight-to-Fourteen
Modulation)
Number of channels 2 stereo channels
Frequency response 5 to 20,000 Hz ±0.8 dB
Signal-to-noise ratio Over 96 dB during playback
Wow and flutter Below measurable limit
Outputs
LINE (ANALOG) OUT Jack type: stereo-mini
Rated output: 1 Vrms (at
50 kilohms)
Load impedance: Over 10 kilohms
PHONES Jack type: stereo-mini
Rated output: 5 mW
Load impedance: 32 ohms
General
USB port series B, self powerd, full speed
Where purchased Power requirements*
USA and Canada 120 V AC, 60 Hz
Europe and Other 220 – 230 V AC, 50/60 Hz
countries
* Using an AC power adaptor (supplied)
Power consumption 6 W
152 × 52 × 249 mm (w/h/d) incl.
Dimensions (approx.)
projecting parts and controls
Mass (approx.) 1.0 kg
Supplied accessories
See page 3.
US and foreign patents licensed from Dolby
Laboratories Licensing Corporation.
Design and specifications are subject to change
without notice.
GB
11