Precautions - Sony MDS-NT1 Mode D'emploi

Precautions

The nameplate is located on the bottom exterior.
On safety
• Should any solid object or liquid fall into the
cabinet, unplug the deck and have it checked by
qualified personnel before operating it any
further.
• Caution–The use of optical instruments with
this product will increase eye hazard.
On power sources
• Before operating the deck, check that the
operating voltage of the deck is identical with
your local power supply. The operating voltage
is indicated on the nameplate on the AC power
adaptor.
• The unit is not disconnected from the AC
power source (mains) as long as it is connected
to the wall outlet, even if the unit itself has been
turned off.
• If you are not going to use the deck for a long
time, be sure to disconnect the AC power
adaptor from the wall outlet. To disconnect the
AC power adaptor, grasp the plug itself; never
pull the cord.
• AC power adaptor must be changed only at the
qualified service shop.
On condensation in the deck
If the deck is brought directly from a cold to a
warm location, or is placed in a very damp room,
moisture may condense on the lenses inside the
deck. Should this occur, the deck may not operate
properly. In this case, remove the MD and leave
the deck turned on for several hours until the
moisture evaporates.
On the MiniDisc cartridge
• Do not open the shutter to expose the MD.
• Do not place the cartridge where it will be
subject to extremes of sunlight, temperature,
moisture or dust.
GB
8
On cleaning
Clean the cabinet, panel and controls with a soft
cloth slightly moistened with a mild detergent
solution. Do not use any type of abrasive pad,
scouring powder or solvent such as alcohol or
benzine.
If you have any questions or problems concerning
your deck, please consult your nearest Sony
dealer.