Safety Instructions; During Operation - ergoCentric upCentric UPMOD-2L Guide De L'utilisateur

Safety instructions

Before installation/re-installation
Make sure that the table is being installed as described in the
"Assembly instructions" section of this owner's manual. When installing
and using electrical equipment, basic s afety precautions should always
be followed to avoid a risk of fire, electric shock, or injury to persons:
1. If the power cord is damaged it must be replaced.
2. Do not open any electrical components
( control box, motor housing, handset ).
3. Never drop or insert any object into any opening.
4. M ake sure the correct tools and assembly parts
are used when assembling the system.
5. B efore transporting the table, always remove
the power cord from main power supply.

During operation

1. Not intended for use by children.
2. For indoor use only.
3. Do not use table when the load exceeds the maximum capacity.
See page 5 for weight limits.
4. Always unplug the table from the electrical outlet before cleaning.
5. Unplug from outlet before installing or removing parts.
6. Keep the cord away from heated surfaces.
7. Do not operate where aerosol ( spray ) products are being used
or where oxygen is being administered.
8. To disconnect, lower table to minimum height, then remove
plug from outlet.
9. I f table is heavily loaded, keep load away from edges to prevent
the possibility of the table tipping over.
10. A ny servicing is to be performed by an authorized service
representative. Contact
for more information.
11. M ake sure that no persons or items will collide with the table when
adjusting upwards and downwards.
12. I f the control box or the legs make any unusual noises or smells,
immediately unplug table from power supply.
6 upCentric – UPMOD-2L Owner's Manual | Guide de l'utilisateur
®
service@ergocentric.com or 1 866 438-3746