Important Information - ergoCentric upCentric UPMOD-2L Guide De L'utilisateur

Important information

• Always make sure all screws are tightened before
use of the table and after moving or transporting.
• D uty cycle of the frame for desk is 10 %,
max. 2 minutes operating / min. 18 minutes stop.
• E nsure the loading on each leg is less than the maximum
outlined below, otherwise it might cause permanent damage
to the leg (s) during operation.
Each leg maximum
• W hen the motor cable is connected to the control box, the legs
can maintain an adequate locking force up to the maximum load on
the tabletop. However, when the cable is damaged or is disconnected
from the control box, it will cause the desk to sink to the bottom within
hours if the load on either leg is larger than the maximum capacity.
• M ake sure that no persons or items will collide with the table,
when adjusting upwards and downwards.
• Damaged cords must be replaced before connecting
the main power cable.
• Keep at least 3/4" of free space around the whole frame / tabletop.
• The upCentric
• Do not pull or push the table if adjusting.
• Do not lift the frame or table off of the ground when adjusting.
Table maximum
is not intended to be used as a person lift.
®
upCentric – UPMOD-2L Owner's Manual | Guide de l'utilisateur
®
Load capacity
250 lbs ( 114 kg )
175 lbs ( 80 kg )
5