Switching between metric and imperial units
Press memory buttons ❶ ❷ and ❹ for 5 seconds.
The handset display will show "C-I".
c - i
1
2
3
4
For metric: Press ❷, the handset display will show "C" for centimeters.
For imperial: Press ❸, the handset display will show "I" for inches.
Note: Imperial units (inches) are the default UOM.
Setting up parallel connectivity
A Y-splitter cable is required to parallel connect two 2L frames to adjust
as one.
Make sure both tables are adjusted to the lowest position.
Plug both "male" ends of the Y-splitter cable into the H port of both
control boxes.
Plug the "male" end of the handset cable into the "female" end of the
Y-splitter cable.
Synchronize all 4 legs together – press and hold
and
buttons together.
The control boxes will beep twice to notify you that they are now
parallel connected.
Troubleshooting
This guide is to provide general instructions to troubleshoot your
upCentric
height adjustable table.
®
WARNING
Ensure the desk is free to move and not obstructed.
Personnel should use caution to prevent injury from a desk in motion.
Please note this is a general guide and not absolute.
14
upCentric
– UPMOD-2L Owner's Manual | Guide de l'utilisateur
®