Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Compressor Pressure Adjustment (Fig. 6)
The compressor pressure is factory set and must be checked
and adjusted by qualified technicians only. Tampering with the unit may
be dangerous.
Remove pressure gauge cap. Connect a pressure gauge on the pressure
measuring port on the rear guard. Start heater and read air pressure value. If
necessary adjust pressure to the correct value turning the adjusting screw (the air
vent hole in the adjusting screw middle) clockwise to increase, anticlockwise to
decrease the pressure:
Fig.6
Electrical
Inspect cables, electrical parts and connections.
Model
Air Pressure (bar)
CAC20KW
CAC30KW
CAC50KW
0.32
0.31
0.45
48
Publicité
Table des Matières
