Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
TOOLS REQUIRED:
6 mm T-Wrench
5 mm L-Wrench
Screwdriver (not included)
PARTS INCLUDED:
2 Console Masts
1 Console Assembly
2 Sets Console Mast Covers
1 Accessory Tray
2 Water Bottle Pockets
1 Hardware Kit
1 Safety Key
1 Power Cord
1 Audio Adapter Cable
1 Bottle of Silicone Lubricant
(for 2 applications)
NEED HELP?
If you have questions or if
there are any missing parts,
contact Customer Tech
Support. Contact information
is located on the back panel
of this manual.
PRE ASSEMBLY
UNPACKING
Place the treadmill carton on a level flat surface. It is recommended that you place
a protective covering on your floor. Take CAUTION when handling and transporting
this unit. Never open box when it is on its side. Once the banding straps have been
removed, do not lift or transport this unit unless it is fully assembled and in the upright
folded position, with the lock latch secure. Unpack and assemble the unit where it
will be used. The enclosed treadmill is equipped with high-pressure shocks and may
spring open if mishandled. Never grab hold of any portion of the incline frame and
attempt to lift or move the treadmill.
WARNING
DO NOT ATTEMPT TO LIFT THE TREADMILL! Do not move or lift treadmill
from packaging until specified to do so in the assembly instructions. You
may remove the plastic wrap from console masts.
WARNING
FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN INJURY!
NOTE:
• During each assembly step, ensure that ALL nuts and bolts are in place and
partially threaded in before completely tightening any ONE bolt.
• A light application of grease may aid in the installation of hardware. Any grease,
such as lithium bike grease is recommended.
• It is recommended that two people work together for ease and efficiency while
assembling an treadmill.
9
Publicité
Table des Matières
